Universal converter

LD 7735297
Universal converter
Universal converter
Universal converter

This product is classified as a dangerous good and is not available for online purchase.

For ordering the dangerous good or other information please contact our customer service center.
This experiment/set up contains dangerous goods.
These are not available for online purchase.
You may order the experiment/set up without the dangerous goods.


For ordering the dangerous good or other information please contact our customer service center.
Email: webshopuk@ld-didactic.de
Telephone:+49 (0) 22 33 / 604 – 319
Go to contact form

˟

Request an offer

Thank you for your inquiry. We will get back to you as soon as possible.

˟

Description

Transistor pulse converter with voltage link for the generation of a three-phase, frequency and amplitude-variable output voltage from an AC mains. This unit in conjunction with the corresponding control unit is used to assemble a frequency converter or servo amplifier.

Technical description:
  • Single-phase mains connection
  • Variable link voltage due to fully controlled B2C rectifier bridge circuitry
  • Three-phase inverter built with IGBT (insulated gate bipolar transistor)
  • Maximum switching frequency 20 kHz, resulting in good approximation of sinusoidal current as well as low noise build-up in the machine
  • Output short-circuit-proof, earth-fault-proof and switch-proof
  • Interface for connection of the control unit (25-pin sub-D socket, TTL level)
  • Each individual transistor can be switched on and off via the interface and is protected from damage with an interlocking device
  • The respective activated IGBT's are displayed via LEDs
  • Monitoring of the variable link voltage, temperature rise in machines and converter, excess currents in the rectifier and converter. Output of the switching status via interface and display via LEDs
  • Integrated brake chopper
  • Safe galvanic isolation (SELV) between the power component and the control unit
  • Output currents are detected via Hall generators. Electrically separated output via interface
  • Two-stage mains filter for the reduction of the line-bound interference
  • Three-phase motor filter for the reduction of the edge steepness of the pulse voltages at the converter output to values < 250 V/µs

Technical data

  • Output voltage (UA): 3 x 0...230 V
  • Output current (IA): max. 3 x 8 A
  • Supply voltage: 200...240 V, 50/60 Hz via 4 mm safety sockets
  • Maximum switching frequency 20 kHz

Scope of delivery

  • 25-pin connection cable
Print page

Contact Us

Technical Service & Support:

Online Service Portal
Do you have any questions or suggestions regarding our devices, products, experiments, equipment sets or about our software? You need spare parts? FORM

Repair Service
You would like to register a repair? FORM

Europe
For European distributors, please visit: European distributors
Worldwide requests
Please contact us per email: sales@ld-didactic.de

 Click here for our contact form and postal address.

Contact Us